DCA1000EVM:To configure the radar and capture data without using mmWaveStudio

chihiro yoshida

Prodigy 10 points

Part Number: DCA1000EVM
Other Parts Discussed in Thread: AWR1843AOPEVM, MMWAVEICBOOST,

Tool/software:

こんにちは

「AWR1843AOPEVM」+「MMWAVEICBOOST」+「DCA1000EVM」の評価キット構成
を使用して、生のADCデータを取得しています

現在、ソフトウェア「mmWaveStudio」を使用して、レーダーの設定とデータキャプチャを行っています
「mmWaveStudio」を使わずに、PCから直接レーダーの設定やデータ取得を行いたいのですが。

USBやLANに関する技術情報(通信コマンドの詳細など)はありますか?
ご指導を賜りますようお願い申し上げます。

ありがとう、そしてよろしく、

吉田千尋

3 months ago

+1 Cesar 3 months ago

TI__Guru*** 147964 points

WE have a tool called studio cli available in the radar toolbox.

C:\data-nobackup\2025\radar_toolbox_3_00_00_05\tools\studio_cli

(it is also in the latest radar toolbox release on TI Resource Explorer)

This tools performs the configuration without mmwave Studio.

It uses instead target code that runs on the evm.

The data is still captured using the DCA1000 board

Please take a look at it.

Thank you

Cesar

0 chihiro yoshida 2 months ago in reply to Cesar

Prodigy 10 points

Hello,
I apologize for the delay in following up after asking my question.
Thank you for providing information about Studio_CLI.
Based on your response, I think I will be able to make progress with my work.

Thank you, Cesar, for your answer.
If I have further questions, I may reach out again, so I would appreciate your support at that time.
Thank you, and I look forward to working with you.

chihiro yoshida

0 Cesar 2 months ago in reply to chihiro yoshida

TI__Guru*** 147964 points

Thank you

Cesar

Sensors

Sensors forum

DCA1000EVM:To configure the radar and capture data without using mmWaveStudio