Other Parts Discussed in Thread: UNIFLASH
Hi Team,
Posting on behalf of our customer.
I am using an IWR6843AOPEVM board. I successfully flashed the board using UniFlash with the following firmware:
• xwr64xxAOP_mmw_demo.bin
SOP switches were set correctly:
• SOP3 ON during flashing
• All SOP OFF during functional mode
After reset, I am seeing:
• Blank screen on CLI UART (115200 baud)
• No data output on data UART
• No response when sending CFG file
The board is powered and detected over USB, but no console output appears.
Could you please advise:
1. Whether this behavior indicates corrupted firmware or hardware fault?
2. Recommended binaries for my board revision
3. Any recovery steps?
Board: IWR6843AOPEVM
Flashing tool: UniFlash
Host: Jetson Orin Nano / Windows PC
Regards,
Danilo
