Compiler/LDC1314DIAL-EVM: code and command issue

Yida Liu

Part Number: LDC1314DIAL-EVM
Other Parts Discussed in Thread: LDC1314

Tool/software: TI C/C++ Compiler

Hello everyone,

I am try to using a LDC1314 1 degree dial to determine the position. And I am wondering if there is a way or commands that can extract the inductor value in the LDC1314 which is converted into the angle values in the GUI.

Thank you.

over 7 years ago

0 Ben Kasemsadeh over 7 years ago

TI__Genius 13650 points

Hello Yida,
there is unfortunately no way to extract the raw code from the GUI. I will find out tomorrow if there is another way to get the inductance data and will get back to you then. .

0 Yida Liu over 7 years ago in reply to Ben Kasemsadeh

Prodigy 20 points

Thank you so much for your replying.
And yes, I think I would like to know the inductance data or any values that were used to be converted to angle values.
Thank again.

Sensors

Sensors forum

Compiler/LDC1314DIAL-EVM: code and command issue