DCA1000EVM: Which signals are needed to capture data on LVDS

Kevin.Y

Intellectual 455 points

Part Number: DCA1000EVM
Other Parts Discussed in Thread: AWR1642

Hi,

I found the new useful tool DCA1000.

I'm thinking to capture raw data from AWR1642 with DCA1000.

To do this, which signals are needed?

There is only limited space on my board so it is not possible to connect all 60 pins on AWR1642 EVM.

If you give me any ideas, that would be very helpful.

Thanks in advance.

Best Regards,

-Kevin

over 7 years ago

0 Cesar over 7 years ago

TI__Guru**** 150704 points

Hi,

Please follow the directions in the "DCA1000_Quick_Start_Guide.pptx"

If this is not sufficient please let us know

thank you
Cesar

0 KUO LEO over 7 years ago in reply to Cesar

Prodigy 40 points

Hi Cesar,
I also have same question. If our board only can use 16pin connector. Which signal in DCA1000 do I need connect to 16pin connector? I checked "DCA1000_Quick_Start_Guide.pptx", but it don't have related description.

0 aozer over 7 years ago in reply to KUO LEO

TI__Mastermind 31145 points

Hello Kuo,

Please consult Table 5 in the User's Guide. You can use the table to determine which signals you will require based on which interfaces your design needs.

Regards,

Adrian

Sensors

Sensors forum

DCA1000EVM: Which signals are needed to capture data on LVDS