Using HDCypar part for temperature and humidity measurement in our system.
The measurement values are 61% and 25'C, but should be 84% and 12'C as real.
How to calibrate them? just write 0x1000 @0x2 and read each 14bits and calculate by provided equations.
Pls. giude on this matter.
Vrai
Dear Vrai -
Can you confirm that you are also trigger the measurements by executing a pointer write transaction with the address pointer set to 0x00?
Refer to Figure 12 on page 13 of the datasheet, here: 
If possible, also provide logic analyzer captures if possible, Saleae logic files would be handy if you have one of those and can provide.
