This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

IWR6843: Using this board with MMWAVEPOEEVM and Traffic Monitoring Demo

Part Number: IWR6843
Other Parts Discussed in Thread: MMWAVEPOEEVM, MMWAVEICBOOST


First of all, I managed to run the Traffic Monitoring Demo with the ISR6843 in standalone mode, using Matlab. I'm trying to understand what is the MUX configuration that will allow me to use UART (like in regular matlab), but with the POE board powering the IWR6842. Because with the suggested pin configuration found in MMWAVEPOEEVM Power Over Ethernet Solution guide(PDF), I get the UART ports, and it says ports 

opened but no response received. Check port number and SOP mode. So I think its something related to the mux configuration.

Ideally in the future, I'd like to use the Ethernet Cable as power and data with the Traffic Monitoring Demo, would there be any guide that could point me towards that direction?

Thank you for everything in first place.

My best regards,