AWR1642: The AWR1642 Boost Board's 60-pin HD Connector problem

liang yu chou

Part Number: AWR1642
Other Parts Discussed in Thread: DCA1000EVM

I want to do mmwave Tx and Rx test and measurement in our AWR1642 module PCB, It is not AWR1642 Boost EVM,

it is a customized PCB.

I need to connect it to mmwave DevPack or DCA1000EVM by the 60-pin HD Connector, which pins are necessary to connect from

customized AWR1642 Radar? Or TI can provide adapter let me use? 60-pin is too much.

Thank You

Liang-Yu

over 6 years ago

0 Anand Gadiyar over 6 years ago

TI__Genius 15005 points

Hi Cheng,

We're looking into the minimum set of pins needed and will get back to you on this shortly.

I'm afraid we do not have an adapter for this interface.

Best Regards,
Anand

0 Jitendra Gupta over 6 years ago

TI__Guru 69960 points

Hi,

In the following snapshot, I marked the required pins which need to connect from AWR1642 to DCA1000 connector.

When RS232Rx/Tx lines are connected with DCA1000, it'll be enumerated under FTDI device as 3rd COM port.

Regards,

Jitendra

Sensors

Sensors forum

AWR1642: The AWR1642 Boost Board's 60-pin HD Connector problem