IWR1443BOOST: How to use the CalibData.txt and PhaseShiftCalibData.txt

Hi,

You can find some information about the calibration session in mmwave studio user guide. 

C:/ti/mmwave_studio_02_00_00_02/docs/mmwave_studio_user_guide.pdf

But usually you just enable the RF init calibration, and you do not need to load any calibration data. 

Best,

Zigang

Dear Zigang,

Thanks for your supports,

You know, after tun the mmWaveStudio.exe, there will product "CalibData.txt and PhaseShiftCalibData.txt".

When run the lab, C:\ti\mmwave_industrial_toolbox_3_3_1__win\mmwave_industrial_toolbox_3_3_1\labs\lab0016_zone_occ_14xx\gui;

How to load the calibration data in to the lab firmware or config file;

thanks;

HI,

The mmwave demo code will automatically run the RF calibration during power on, so you do not need to load those calibration data to the system.

Best,

Zigang

Dear Zigang,

Thanks for your supports,

when run  mmWaveStudio.exe, the downloaded file is xwr12xx_xwr14xx_radarss.bin;

but normally working, the downlaod file is xwr14xx_mmw_demo.bin; so the RF calibration will be erased,  how to used the calibration data into new firmware?