MMWAVE-STUDIO: matlab PostProc source code available ?

Naoki Kawada

Guru 19890 points

Part Number: MMWAVE-STUDIO

Hi,

I`m considering about matlab processing for the captured raw data in DCA1000 and mmWaveStudio. mmWaveStudio supports PostProc by default. I`m wondering if you could share the matlab PostProc source code for our reference. Or, can you share the another code to be my stating point ? Thank you for your suggestion in advance.

Best Regards,
NK

over 6 years ago

0 Jitendra Gupta over 6 years ago

TI__Guru 69960 points

Hi Naoki,
I'm afraid that Matlab PostProc script source is not available.
You can go over the mmwave_studio_userguide to get information about raw capture data format and further use Matlab radar signal processing to do FFTs.

Regards,
Jitendra

0 Naoki Kawada over 6 years ago in reply to Jitendra Gupta

Guru 19890 points

Jitendra, Thanks for your answer. Understood. I close the thread.

Best Regards,
NK

0 Jitendra Gupta over 6 years ago in reply to Naoki Kawada

TI__Guru 69960 points

Hi Naoki,
There is an app-note on the same context will help you to implement processing chain.
www.ti.com/.../swra581b.pdf

Regards,
Jitendra

0 Naoki Kawada over 6 years ago in reply to Jitendra Gupta

Guru 19890 points

Ok, thanks! That would help me.

Best Regards,
NK

Sensors

Sensors forum

MMWAVE-STUDIO: matlab PostProc source code available ?