• State TI Thinks Resolved
  • Locked Locked
  • Replies 5 replies
  • Answers 2 answers
  • Subscribers 16 subscribers
  • Views 365 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TS3L501E: Application use case

JH Shin
Mastermind 7060 points
Part Number: TS3L501E

Hello,

My customer is considering using the TS3L501E in the following application:

Is it okay to use TS3L501E for the above use case?

In particular, can the TS3L501E be damaged by ESD coming from the RJ45 connector? Do you have any workarounds for this?

Thank you.

JH

  • 0
    TI__Expert 3515 points

    Hi JH,

    The block diagram looks good, the TS3L501E is a 2:1 ethernet multiplexer that has built in ESD protection up to the rating in table 6.2 on the datasheet. If their application has a risk of ESD events greater than the rating, then the device can be damaged unless further protection is added to the circuit. I would ask your customer for further clarity on the level of ESD events they expect so the correct level of protection can be recommended.

    Thanks,
    Tyler

  • 0 in reply to Tyler McGuire
    Mastermind 7060 points

    Hi Tyler,

    Thanks for your help.

    Could you please review whether the TS3L501E has no problems with the application below?

    Thanks,

    JH

  • 0 in reply to JH Shin
    TI__Expert 3515 points

    Hi JH,

    What is meant by Hot-Swap in the block diagram? Will the TS3L501E remain powered on but only the I/Os be floated?

    Thanks,
    Tyler

  • 0 in reply to Tyler McGuire
    Mastermind 7060 points

    Hi Tyler,

    All three units can be mounted and dismounted from the M/B.

    When the right unit with the TS3L501E is dismounted and mounted, TS3L501E's power is turned off and on.

    However, if the left two units are dismounted and mounted, the TS3L501E's power of right unit remains intact.

    Could there be a problem with the TS3L501E application they plan to use?

    Thanks,

    JH

  • 0 in reply to JH Shin
    TI__Expert 3515 points

    Hi JH,

    There shouldn't be an issue if any of the boards are dismounted, the only concern is when the TS3L501E is powered off and voltage is applied to the IOs. It is recommended to power up VDD first then apply voltage to the IOs but as long as the voltages are withing the absolute max rating, there shouldn't be damage to the device.

    Thanks,
    Tyler