Hi,
When we do not apply signals (IN1 and IN2) then what will be the default condition of below switch?
Please share your comments.
Thanks,
Kiranjit
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi,
When we do not apply signals (IN1 and IN2) then what will be the default condition of below switch?
Please share your comments.
Thanks,
Kiranjit
Hi Clemens,
Thanks for your response.
It means that it will not select among NO0,NO1 and NO2 instead of oscillating.
Thanks,
Kiranjit
Clemens Ladisch When both IN signals are low then what will be the output of COM?
Hello Kiranjit,
To add to what clemens said if both (IN1 and IN2) are low the internal switch will not be connected to any input and that means there will be no signal on the output.
Thanks and Regards,
Kameron