TMUX136: OE directly to ground?

Zach Kimble

Intellectual 1255 points

Part Number: TMUX136

Hello,

On TMUX136, can I connect the OE pin directly to ground? Or should I place a resistor between the pin and ground?

Thank you!

Best regards,

Zach Kimble

over 1 year ago

+1 Rami Mooti1 over 1 year ago

TI__Mastermind 28308 points

Hey Zach,

Yes, the enable pin can be tied directly to ground. Of course, you'll lose functionality of it and won't be able to isolate the device channels but if you don't care about that functionality, then grounding it directly is fine.

Thanks!
Rami

0 Zach Kimble 12 months ago in reply to Rami Mooti1

TI__Intellectual 1255 points

Thank you Rami! I plan to always keep the device enabled when there is power on the VCC pin so not being able to control EN is not an issue for me.

Switches & multiplexers

Switches & multiplexers forum

TMUX136: OE directly to ground?