Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

  • State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 16 subscribers
  • Views 435 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Switch Selection by Bandwidth

Paul Bryson
Intellectual 490 points
Other Parts Discussed in Thread: TS3USB3200

I am trying to select an analog switch and high bandwidth (>>100MHz) is a critical parameter.  But the parametric guides do not include bandwidth or capacitance as criteria.  Any suggestions on how to proceed.  Digging though the datasheets one by one is getting very tedious.

I was looking at the TS3USB3200 but my CM wants $5 each to put QFNs on the PCB.

  • 0
    TI__Expert 6395 points

    Hello Paul,

    If you visit ti.com/switches and select one of the product trees on the left side of the page, this will take you to a table where you can view the switches TI offers and filter out parameters such as channels, configuration, and Bandwidth.

    Here is the link for the 5 V or less analog switch page: http://www.ti.com/lsds/ti/switches-multiplexers/analog-switch-multiplexer-less-product.page

    USB page: http://www.ti.com/lsds/ti/interface/usb-switch-products.page?familyAliasId=1201646&paramCriteria=no

    Regards,

    Andrew