TS3USB3031 / use as MyDP 1:3 switch

K.Yaita

Guru 29710 points

Other Parts Discussed in Thread: TS3USB3031

Hi team,

I can understand TS3USB3031 is MyDP and dual USB 2.0 High-Speed switch.

Is it possible to use the device as MyDP 1:3 switch?

My customer want to use this device as MyDP 1:3 switch.

Best Regards,

Yaita / Japan disty

over 10 years ago

0 C. Ryan Land over 10 years ago

TI__Genius 9860 points

Hi Kensuke,

I am looking into this question for you.

0 C. Ryan Land over 10 years ago in reply to C. Ryan Land

TI__Genius 9860 points

Hi Kensuke,

Yes, you can use it as a MyDP 1:3 switch.

-Ryan

0 K.Yaita over 10 years ago in reply to C. Ryan Land

Guru 29710 points

Hi Ryan-san,

Thank you for your quick reply!

I will inform my customer about that.

Best Regards,

Yaita

0 K.Yaita over 10 years ago in reply to K.Yaita

Guru 29710 points

Ryan-san,

My cutomer asked me additional question.

Is there any difference between MyDP(MHL) switch and USB switches in TS3USB3031?

It seems these have different Ron and Con but the test conditions are also different.

Best Regards,

Yaita

0 C. Ryan Land over 10 years ago in reply to K.Yaita

TI__Genius 9860 points

The switch paths are similar, and they can all be used for the same purpose. The spec differences are due to minor optimizations for each protocol. The test differences are due to different USB vs. MHL spec operating voltages.

-Ryan

0 K.Yaita over 10 years ago in reply to C. Ryan Land

Guru 29710 points

Ryan-san,

I appreciated for your support.

Best Regards,

Yaita

Switches & multiplexers

Switches & multiplexers forum

TS3USB3031 / use as MyDP 1:3 switch