Hi guys,
are there protection diodes inside that CMOS devices? Which max. current are they capable if there are some?
The question is if I need external protection diodes due to over voltage above 5.5V.
Thanks,
Markus
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi guys,
are there protection diodes inside that CMOS devices? Which max. current are they capable if there are some?
The question is if I need external protection diodes due to over voltage above 5.5V.
Thanks,
Markus
The absolute maximum ratings imply that there are diodes. (See [FAQ] Can the input voltage (Vi) to my logic device be higher than the supply voltage (Vcc)?)
The limit (which you should stay away from) is 20 mA.
Hi Clemens,
ok thanks - so you mean the statement "DC Input Diode Current, Iik +/-20mA" at the abs max Ratings tells it.
There is written "for Vi > Vcc + 0.5V". Does that mean I also could go up to Vi = 10V if the current is e.g. just 1mA?
Normally the datasheets only writing Vccmax = e.g. 5V + 0.5V allows not more voltage :-s
BR,
Markus
If there is a means to limit the current (typically, a series resistor), then the diode will clamp the voltage at the pin, and the chip will not actually see 10 V.
Hi Markus,
As Clemens has mentioned when using a series limiting resistor it helps prevent the part from damage by reducing current and how the voltage will not see the same high voltage. For this part that is +/-20mA. However one of the consequences of adding larger current limiting resistors is that you can add to the insertion loss of the switch system which may not be suitable for all applications. In the case where there may be more current present than the +/-20 mA external protection devices would be suggested.
Best,
Parker Dodson