GEL error

raghu gundaala

Other Parts Discussed in Thread: TMS320F28377D

hi.. in my pc i install ccs with 90 days for debugging support but when ever i tried to debugging that error is coming like " C288xx_CPU1:GEL error while executing ontargetconnect(); identifier not found: ST1 AT st1 = (st1&~(0X0100))"

please help me to solve this error .

over 9 years ago

0 AartiG over 9 years ago

TI__Guru**** 173310 points

Which version of CCS are you using and which target board? Is it a TI kit or a custom board?

Also please post the complete error message that appears in the CCS console or on the pop-up message. If you could attach a screenshot that would be helpful.

0 raghu gundaala over 9 years ago

Intellectual 610 points

hi. this is raghu ... in my pc i am using ..

ccs version-6.0.1.00040

and below there is a screen short .

0 AartiG over 9 years ago in reply to raghu gundaala

TI__Guru**** 173310 points

You did not mention what target board you are using.

This error indicates that the debugger had problems accessing registers/memory locations to perform actions defined in the GEL script. This is common for targets not properly initialized or if the GEL file is not valid for that target. Check your target configuration file and make sure it matches your board/emulator.

If your target configuration is correct, and you are using a custom board, then it might point to a hardware issue.

0 raghu gundaala over 9 years ago in reply to AartiG

Intellectual 610 points

sorry for the delay

we are using tms320f28377d control card with dock station still we are getting same error.

Code Composer Studio™︎

Code Composer Studio forum

GEL error