CC1350STK: I want to use energytrace and capture the current consumption of CC1350STK sensor tag.

Pukhraj Singh

Part Number: CC1350STK
Other Parts Discussed in Thread: ENERGYTRACE, , CC1350

Hello,

I have a CC1350STK sensor tag. I want to do an Energytrace analysis on them to figure out their current consumption. Can you let me know how can I do it? I tried to use Dev Debugger with CC1350STK but, it's not working and showing this error, I tried to unplug and plug back in but it is still the same, help me with this.

Thank you!

Best regards,

Pukhraj Singh

over 2 years ago

0 Sid over 2 years ago

TI__Mastermind 20412 points

Hi Pukhraj,

I would assume the same configuration as the LPSTK CC1352. Just power the board with 3.3 and GND ping from another XDS-110 board. This should allow you to measure current consumed by the board.

Regards,

Sid

0 Pukhraj Singh over 2 years ago in reply to Sid

Intellectual 375 points

Well this thread is for CC1350STK, It is a different sensor tag that requires dev debugger for flashing in the code

Thank you,

Best regards,

Pukhraj Singh

+1 Sid over 2 years ago in reply to Pukhraj Singh

TI__Mastermind 20412 points

Hi Pukhraj,

I looked up the CC1350 STK, the debug Devpack doesn't have Energy Trace capabilities. So, energy trace cannot be used with this dev kit. Please use alternate methods to measure current.
Sid

Code Composer Studio™︎

Code Composer Studio forum

CC1350STK: I want to use energytrace and capture the current consumption of CC1350STK sensor tag.