HI Champs,
could you please help with the following question:
What port number (range from 1-65535) and what protocol (UDP, TCP, etc…) is used when CCS is communicating with LAN emulators?
FYI, Spectrum Digital referred back to us on that question ...
Kind regards,
one and zero
Hi,
From the 560v2 configuration program you can check the ports used by the JTAG debugger. For example, the BH560v2 Config Utility shows:
With the JTAG debugger connected to a target, you can also issue the command netstat from the Windows command prompt. You should get the TCP connection established with the port 55755 - by both my Spectrum Digital and my BlackHawk XDS560v2 STM emulators use the same ports, as shown below:
C:\Users\user>netstat
Active Connections
Proto Local Address Foreign Address State
(...)
TCP 128.247.71.227:60558 dhcp-128-247-71-36:55755 ESTABLISHED
TCP 128.247.71.227:60564 dhcp-128-247-71-36:55755 ESTABLISHED
(...)
Hope this helps,
Rafael
