This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

CCS/TMDX5505EZDSP: Cannot connect to target

Part Number: TMDX5505EZDSP
Other Parts Discussed in Thread: TMS320C5505

Tool/software: Code Composer Studio


I just unpacked a new TMS320C5505 eZdsp stick for a class and I'm having trouble connecting and even running the basic Hello World example.

I'm using CCS version 7 (newly downloaded) and ran the check for updates. This is used on Windows 10.

I verified that the XDS 100 drivers were installed correctly (this was a check point on another thread). Screenshot of my target configuration is shown.

The output from the "test connection" is also shown below. Any suggestions? Thank you.



[Start: Texas Instruments XDS100v1 USB Debug Probe_0]
Execute the command:

%ccs_base%/common/uscif/dbgjtag -f %boarddatafile% -rv -o -F inform,logfile=yes -S pathlength -S integrity


-----[Print the board config pathname(s)]------------------------------------


-----[Print the reset-command software log-file]-----------------------------

This utility has selected a 100- or 510-class product.
This utility will load the adapter 'jioserdesusb.dll'.
The library build date was 'Dec 13 2016'.
The library build time was '11:56:15'.
The library package version is '6.0.504.2'.
The library component version is ''.
The controller does not use a programmable FPGA.
The controller has a version number of '4' (0x00000004).
The controller has an insertion length of '0' (0x00000000).
This utility will attempt to reset the controller.
This utility has successfully reset the controller.

-----[Print the reset-command hardware log-file]-----------------------------

The scan-path will be reset by toggling the JTAG TRST signal.
The controller is the FTDI FT2232 with USB interface.
The link from controller to target is direct (without cable).
The software is configured for FTDI FT2232 features.
The controller cannot monitor the value on the EMU[0] pin.
The controller cannot monitor the value on the EMU[1] pin.
The controller cannot control the timing on output pins.
The controller cannot control the timing on input pins.
The scan-path link-delay has been set to exactly '0' (0x0000).

An error occurred while hard opening the controller.

-----[An error has occurred and this utility has aborted]--------------------

This error is generated by TI's USCIF driver or utilities.

The value is '-150' (0xffffff6a).
The title is 'SC_ERR_FTDI_FAIL'.

The explanation is:
One of the FTDI driver functions used during
configuration returned a invalid status or an error.

[End: Texas Instruments XDS100v1 USB Debug Probe_0]