CCS/TMS320DM8127: CCS project can't run on DM8127CSK

le hai

Part Number: TMS320DM8127

Tool/software: Code Composer Studio

HI Experts,

I'm using board DM8127CSK and I encounter some problems with setting it up.

1 . I try to build and run a simple Hello word program in CCS v8, but it responds that " Device is held in reset. Take it out of reset ,then try again " (picture below)

Can you tell me where problems might be ?

In addition, I have also some problems with booting my board, both by SD card or NAND mode. Can it be the reason ?

2. I try to boot my board my using IPNC like instructions in this link:

http://processors.wiki.ti.com/index.php/IPNC_RDK_DM38x_,_DM8127

but even though I follow them correctly, the board refuses to boot up ???? Can someone with experiences can help me with this ? I really appreciate if someone could help me to make it run even just a simple program

Thanks so much :::)))))

over 6 years ago

0 Chester Gillon over 6 years ago

Guru 92251 points

le hai said:
1 . I try to build and run a simple Hello word program in CCS v8, but it responds that " Device is held in reset. Take it out of reset ,then try again "

Sounds like the debugger tried to load on one of the Cortex-M3 CPUs used to control the image subsystem. Whereas I assume you wanted to load the Hello World program on the Cortex-A8.

When launching a debug session you should only select the CortexA8. See https://e2e.ti.com/support/tools/ccs/f/81/p/783073/2895841#2895841 for a similar issue on a different device.

0 le hai over 6 years ago in reply to Chester Gillon

Prodigy 180 points

yeah, seem like It works. Thank you Gillon !

Code Composer Studio™︎

Code Composer Studio forum

CCS/TMS320DM8127: CCS project can't run on DM8127CSK