CCS/CC-DEVPACK-DEBUG: CCS/CC-DEVPACK-DEBUG

VASILII ZABIIAKA1

Tool/software: Code Composer Studio

Hi,

i have 2 CC-DEVPACK-DEBUG and one was bricked. I try connect ITDO (on P1) to ground to recovery bootloader and firmware but device not define by Windows 10 )Device Descriptor Request Failed).

Next, i connect P1 signals from bricked CC-DEVPACK-DEBUG to J2 of working CC-DEVPACK-DEBUG.

But i can't find a way to program one CC-DEVPACK-DEBUG from another.

Can you say about the way to flash boot_loader.bin and and later firmware.bin ?

Thanks in advance

over 4 years ago

0 VASILII ZABIIAKA1 over 4 years ago

Prodigy 40 points

Resolved with CCS 9

0 Ki over 4 years ago in reply to VASILII ZABIIAKA1

TI__Guru**** 420650 points

Thanks for the update. What version were you using before?

0 VASILII ZABIIAKA1 over 4 years ago in reply to Ki

Prodigy 40 points

Hi,

never use CCS before.

I start firmware update and power down. So FW and bootloader (don't know why) damaged.

My JLink not support cJTAG so i take other CC-DEVPACK-DEBUG and create empty project under CCS (download latest from TI).

Start debug session and use Load memory from menu.

Upload latest bootloader to damaged CC-DEVPACK-DEBUG via working CC-DEVPACK-DEBUG.

I can't found standalone flash tool for CC-DEVPACK-DEBUG (XDS110).

Now remove CCS and back to IAR and Keil.

Best wishes

Code Composer Studio™︎

Code Composer Studio forum

CCS/CC-DEVPACK-DEBUG: CCS/CC-DEVPACK-DEBUG