TINA-TI / Monte carlo method for OPA2209,OPA2211A

Ryuji

Guru 20090 points

Other Parts Discussed in Thread: TINA-TI, OPA2211A, OPA2209

Hello,

Can we use Monte carlo method by TINA-TI ?

If yes, please kindly let me know how to use.

-Device

OPA2209 , OPA2211A

-Circuit

Active filter (designed by Filter PRO)

Best Regards,

Ryuji Asaka

0 MaciejKucia over 10 years ago

I am not 100% sure but I think you need full TINA for monte carlo simulation.

Regards,
Maciej

0 Britt Brooks - Online Design Tools over 10 years ago in reply to MaciejKucia

Ryuji,

The formal Monte Carlo analysis is not supported in TINA-TI. You can sweep variable values for worst case/sensitivity analysis.

Simply click on the Select Control Object button:

And click on the component you want to vary (you cannot vary IC's). Fill out the sweep or select a list of values to use:

Run your simulation and it will plot the results for all cases in the same window. You can use the legend to show the cases.

Britt

0 Ryuji over 10 years ago in reply to Britt Brooks - Online Design Tools

Guru 20090 points

Hello,

Thank you for the ifnormation.

I understood.

Best Regards,

Ryuji Asaka

Simulation, hardware & system design tools forum