This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

  • Resolved

TINA-TI / Monte carlo method for OPA2209,OPA2211A

Guru 20090 points

Replies: 3

Views: 3011

Hello,
 
Can we use Monte carlo method by TINA-TI ?
If yes, please kindly let me know how to use.
 
-Device
 OPA2209 , OPA2211A
 
-Circuit
 Active filter (designed by Filter PRO)
 
Best Regards,
Ryuji Asaka
  • I am not 100% sure but I think you need full TINA for monte carlo simulation. 

    http://www.tina.com/English/tina/tolerance_analysis

    Regards,
    Maciej 

    I help only on forum.

  • In reply to MaciejKucia:

    Ryuji,

    The formal Monte Carlo analysis is not supported in TINA-TI. You can sweep variable values for worst case/sensitivity analysis.

    Simply click on the Select Control Object button:

    And click on the component you want to vary (you cannot vary IC's). Fill out the sweep or select a list of values to use:

    Run your simulation and it will plot the results for all cases in the same window. You can use the legend to show the cases.

    Britt

     

    Britt

    Online Design Tools

  • Guru 20090 points

    In reply to Britt Brooks - Online Design Tools:

    Hello,

    Thank you for the ifnormation.
    I understood.
     
    Best Regards,
    Ryuji Asaka

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.