This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: TIDA-00637
Please kindly help to share with below infromation
1. Part # and Vendor's name of CT on page 27 (Figure 22. system as tested)?
2. Part # and Vendor's name of J1772 CABLE(Figure 22. system as tested)?
2. Question with test result Pic on Page 32.
- Is Blue line Final GFCI TEST SIGNAL and red line is measured on MCU I/O pin?
- Is that correct that blue line is test result that measured on X6-1 connect pin?
- Is Red line is signal of GFCI Fault singal or GFCI+?
3. Use for GFCI TEST SIGNAL
- Is GFCI TEST SIGNAL just for test to check on right activation physically on EVSE reference board?
- Does it mean that MCU make 2Khz freq, and make activate coil on CT and op-amp amplify loopback signal from CT and MCU recongnize this signal?
1. We used a high accuracy 2000:5 (or 100:1) CT. This is an older design that I do not have on hand any longer, but I believe it was a CR Magnetics CR8 series transformer.
2. Any standard J1772 cable can work, we didn't have any specific part number for this. There are many options on sites like Amazon.
3. The blue line is the output op X6-1 (GFCI_TEST), and the red line is GFCI_FAULT
4: Correct, GFCI_TEST just injects a current into the CT to ensure that the system is operating correctly.
As a note, this GFCI subsystem was not tested to full UL or ANSI specifications, and is just a guideline on how a system like this could be developed.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.