TINA/Spice: Noise Generator

Giora Eytan

Expert 1235 points

Other Parts Discussed in Thread: TINA-TI

Tool/software: TINA-TI or Spice Models

Hello

I am looking how to add noise to my circuit.

Is there a noise generator component in tina library?

over 5 years ago

0 Herman Theodorus over 5 years ago

TI__Genius 9775 points

Hi Giora,

Not that I am aware of, but you can use the attached for ac/small signal noise generator. For further questions on this, the easiest is to reach out directly to the www.tina.com and go to the support section.

Vnoise.TSC

Herman

0 Giora Eytan over 5 years ago in reply to Herman Theodorus

Expert 1235 points

Dear Herman,

When I ran transient analysis I got at VOUT the same as the input multiply by the voltage amplification.

Where is the noise?

0 Herman Theodorus over 5 years ago in reply to Giora Eytan

TI__Genius 9775 points

Hi Giora,

The noise generator is only for ac analysis, small signal analysis. I won't work for transient noise analysis.

For specific TINA transient noise analysis capability, please reach out to support section of www.tina.com

Because of the holidays, TI E2E™ design support forum responses will be delayed from Dec. 25 through Jan. 2. Thank you for your patience.

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TINA/Spice: Noise Generator