• State TI Thinks Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 39 subscribers
  • Views 476 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TIDA-00951: TIDA-00951 SW

sambong oum
Prodigy 20 points

Part Number: TIDA-00951

There is no output of pin 35 EPWM5A of TMS320F28035 in TIDA-01281 control board


In the source code, EPWM5A is set by Coldstart state but it is not used.

Q1.Is it possible to BUCK Mode operate without any wave from EPWM5A?

Q2. In what operation is the EPWM5A function activated?

  • 0
    TI__Expert 5920 points

    Hi, sambong

    The isolated bidirectional DC-DC converter has two major modes of operation. When it is working as a backup power supply, it operates as an active clamped current-fed boost converter transferring power from the battery to the 380-V DC bus. When operating as a battery charger, the DC-DC converter works
    as a buck converter transferring power from the 380-V DC bus to the battery. Apart from the two major modes, there is an additional mode for the cold starting the system. This mode is used to start up the TIDA-00951 in case the HV DC bus is completely discharged before board start-up.

  • 0 in reply to Desheng, Guo
    Prodigy 20 points

    As shown in the figure, for driving Q8 and Q9 of the 380V bus side switch, the driving pulse of pin 35 EPWM5A of TMS320F28035 is
    Must be
    However, the function is disabled in the actual firmware.

    Why is the EPWM5A signal on the TMS320F28035 disabled?

  • 0 in reply to sambong oum
    TI__Expert 5920 points

    Hi, sambong

    In the Buck mode, this design works as half bridge converter, Q8 and Q9 is not must have.