Other Parts Discussed in Thread: MSP430F5132
Hi,
I am using TIDA-00120 refrence design for 12V/10A MPPT Charge controller. I would like to use P2.4, P2.5 and P2.6 pins of MSP430 for the LED Indications. In this i am not using GUI/ launch pad to connect to the PC.
I tried to write the Firmware to config the Pins P2.4, P2.5 and P2.6. But i am unable to make the pins either "High". or "Low".
So please suggest me how to config above mentioned pins to use as GPIO pins.
Regards
Naresh