PSpice problem after update

Hi Mateusz,

Please select the second tab at the bottom of the window, "Command Window". Do you see a line that says "Capture> DB is attached"?

If the issue persists, please try to use the 4th menu item under "Help": "Reinstall TI Models and Libraries" to see if it fixes the problem..

Thanks,
JC

Hello,

I did re-installation, but now my Pspice hasn't got communication with server like photo below:

Could you tell me what should I do?

Best regards,

Mateusz

Hi Mateusz,

Did this come up during a simulation? If so, would you please share the project (follow this FAQ: https://e2e.ti.com/support/tools/sim-hw-system-design/f/simulation-hardware-system-design-tools-forum/969692/faq-pspice-for-ti-how-do-i-share-pspice-for-ti-projects) with us?

Thanks,
JC

Hello,

after reinstall TI model and library Pspice started. Now I tried add new component to library. Before update it worked, but now I tried add and I have following issue.

Additionally I checked model which I added before update, which worked in the past, but I have the same problem.

Did you meet with this issue?

Best regards,

Mateusz

Hi Mateusz,

Please click Help, then "TI Models, Products or Application Support".

The library version is shown on the second line from the bottom. If it's too old, please close and relaunch PSpice for TI, then accept the update.

Thanks,
JC

Hello,

It's new:

Have you got different idea?

I meant about library from different supplier than TI.

Best regards,

Mateusz

Hi Mateusz,

This is actually not up-to-date. Please close and launch the tool again to see if you get a prompt for library update. It looks like this:

Thanks,

JC