This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TINA-TI: TINA-TI Voltage controlled current load with Piecewise Linear


is it possible to have a pwl signal controlled current that is triggered to start by a voltage signal from another part of my simulation? 

i have a certain part of my simulation that goes from 0 to 1.8V at a certain point in time, and a current generator with a piecewise linear signal for my desired waveform, but can't figure out how to connect them such to make the waveform start only after the 1.8V

i thought perhaps the VCCS (seperate controlling component) maybe could be used, but not sure.