TIDM-RF430-TEMPSENSE: PCB quote

Sam He

Other Parts Discussed in Thread: TIDM-RF430-TEMPSENSE

Hello,

I would like to manufacture the reference design TIDM-RF430-TEMPSENSE from NextPCB online PCB quote page as a Flexible Polyimide PCB. However, I'm not sure which options I should select. Could you please give advice for the following manufacturing options? In addition, should the drill layer be made as A.Tenting vias, B.Plugged vias, or C.Vias not covered?
Thanks!

over 1 year ago

0 Andreas Mueller over 1 year ago

TI__Genius 12995 points

Hi,

sorry for the delayed response. I was out of office.
I have to catch up on many threads, so please be patient until I can work on your request.

Best Regards,
Andreas.

0 Andreas Mueller over 1 year ago

TI__Genius 12995 points

Hello Sam,

please check if this existing thread can answer your questions.

https://e2e.ti.com/support/tools/simulation-hardware-system-design-tools-group/sim-hw-system-design/f/simulation-hardware-system-design-tools-forum/1111581/tidm-rf430-tempsense-pcb-manufacturing

Best regards,

Andreas.

0 Andreas Mueller over 1 year ago

TI__Genius 12995 points

Hi,

There was no feedback since a while, so I assume this tread is resolved and can be closed. You can still reply to this thread after it is closed, or you can create a new thread.

Best Regards,
Andreas.

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TIDM-RF430-TEMPSENSE: PCB quote