• State TI Thinks Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 2 answers
  • Subscribers 39 subscribers
  • Views 279 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TIDA-010081: TIDA-010081

Venkatesh B
Intellectual 753 points
Part Number: TIDA-010081

TIDA-010080 reference design

How to calculate L5 inductor values,we require current ripple about 2% of Load current 20A.

advise me how to calculate L value here please

Thank you,

venkatesh B

thanks in advance

  • 0
    Intellectual 753 points

    could you please response for this?

    Thank you

    venkatesh B

  • 0 in reply to Venkatesh B
    TI__Intellectual 1790 points

    Hi, the L5 inductor is used to filter output voltage ripple & noise, normally, L5 and C31/C32 will form a 2nd stage LC filter. place the corner frequency at about 1/10 of the swtching frequency will provide sufficient insertion loss, this will give you a start point, pay attention to the parasitic parameter such as ESR.ESL,ESC will also contribute the final ripple and noise as well as the good PCB layout with minimized AC high frequency loop

  • 0
    TI__Intellectual 1055 points

    Hi, Venkatesh,

    Normally, this output inductor is good for output voltage ripple. The inductor value is depending on what you expecting attenuating value. For example, if you want to decrease Delta mV, then according to voltage second balance on inductor. Delta mV=L* Delta Iout/Delta t.

    Thanks.