Tool/software:
We have bought TPS92641EVM. We wanted to connect a MOSFET to the evalutation board (parallel to the LEDs) as given in the circuit diagram of TPS92641. What is the method of doing the same? is there a provision to solder the mosfet to the board? or connect it to some dedicated pins on the board?
i do see a silver square marked as Q3. But I am not very clear as to where the source drain and gate of my FET needs to be connected.
should source and drain be connected across the LED? Where will the gate be soldered?
Hi Amritha,
I have marked the G(ate), D(rain) and S(ource) of the Q3 footprint in the below figure for your reference.
Best Regards,
Steven
