TIDA-010030: I2C COMMUNICATION

SAPTARSHI BISWAS

Part Number: TIDA-010030
Other Parts Discussed in Thread: BQ76940, BQ34Z100, EV2400

Tool/software:

HI,

1. FOR I2C COMMUNICATION TO HAPPEN WITH MSP430 CONTROLLER AND BQ76940, IS PORT P1 SCL LINES AND SDL LINES TO DO EXTERNAL SHORT WITH SCL AND SDL GAUGE LINES.

2. DOES PULL UP RESISTORS TO ENABLED AT MSP430 CONTROLLER PORT 4.6 AND P4.7TO MAKE IT WORK. OR EXTERNAL PULL UP RESISTORS 10K ARE ENOUGH

REGARDS

S BISWAS

over 1 year ago

0 Ryan Tan over 1 year ago

TI__Expert 3356 points

Hi,

I have looped in our designer and please expect 1 more working day for the reply.

Thanks.

Ryan Tan

0 Kian Lin over 1 year ago

TI__Expert 4490 points

Hi S BISWAS,

See my comments below:

Yes. Short P1 to enable the on-board MCU I2C communication. Leave it open to connect it to external I2C controller.
Could you clarify your question? Do you mean the pull up resistor R81,R83?

Kian

0 SAPTARSHI BISWAS over 1 year ago in reply to Kian Lin

Prodigy 110 points

Hi kian Lin,

thanks for the reply, it worked.

2. i was mentioning about internal pull resistors of MCU and external resistors R81, 83.

3. One more Question to add here,

when i want to calibrate BQ34Z100 using EV2400, there was menage on the down screen "NO ACKNOWLEDGEMENT FROM DEVICE". how to solve this?

thanks

S Biswas

0 Kian Lin over 1 year ago in reply to SAPTARSHI BISWAS

TI__Expert 4490 points

Hi S，

You can choose either R81,R83 for pullup or using external pullup. The MOSFET Q18 is added here to enable/disable R83 and R81.
I suggest you initiate a new thread to ask BQ34Z100 related questions because we have other colleagues to support this devices.

BRs

Kian

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TIDA-010030: I2C COMMUNICATION