PSPICE-FOR-TI: Installation PSPICE-FOR-TI on new PC

Hi Sean,

This is in work.

Thanks,
JC

But I don't have any parts in the PSpice Parts Search dialog.
If I want to search LM324A. and 

and show the unalbe to validate the licenses repeated failures will cause the application to exit.

Hi Sean,

Have you reinstalled the tool?

If so and if you keep getting a license error message, please create a debug file:

1. Create a new environment variable "CDS_LIC_QA_TesT". Set it to something like "C:\Cadence\PSpiceTI\LicLog.txt".
2. Run PSpice for TI and wait for the error message, then share the file "C:\Cadence\PSpiceTI\LicLog.tx".
3. Delete the environment variable "CDS_LIC_QA_TesT".
4. share the file LicLog.txt

Step 3 is important because otherwise that file will grow to enormous size over time. We don't want to cause them problems down the road.

Thanks,

JC

Hi JC
I tried reinstalling again, with the same result.
PSpice Part Search also cannot be used.
I tried drawing a circuit diagram to place the source (VCC), but the modeling application wouldn't work with that either.

Hi, do you have anything in this folder?

C:\cds_spb_home\cdssetup\pspTILibDir

-JC

Hi JC

It looks like there are a lot of parts.
It can also be edited in PSpice for TI.
What should I do next?
Thank's.

Hi Sean,

would you please check what the newest files in the folder are?

Thanks,
JC

Yes, it has

.

Hi Sean,

It looks like you don't have the file nom_pspti.ind. Would you please open an example project and run a sim?

C:\Cadence\PSpiceTI\tools\pspice\capture_samples\anasim\example

Thanks,
JC