MOSFET models for Cadence Spectre

Bai Nguyen

Other Parts Discussed in Thread: CSD13303W1015, CSD22202W15

I would like to import the PSPICE model of the MOSFET CSD13303W1015 into Cadence Spectre Simulator. However, the model file is likely encrypted for the use of Orcad only so that Cadence Spectre can not decode the model file. Please advise what I could do to make it work?

over 11 years ago

0 Britt Brooks - Online Design Tools over 11 years ago

TI__Mastermind 41310 points

Bai,

You are correct. All of the NexFET models are encrypted and cannot be used in any simulator other than PSpice version 15.7 or higher. These models require an NDA to be provided in an unencrypted format. If you have a direct TI support contact, please contact them and they can make the request for you. If you do not have a direct TI support person, you can make the request through the TI Customer support website:

http://www-k.ext.ti.com/sc/technical-support/customer-support-centers.htm

Select your region and fill out the information requested. Once an NDA is in place, we can provide the unencrypted model.

Britt

0 Bai Nguyen over 11 years ago in reply to Britt Brooks - Online Design Tools

Prodigy 20 points

Hi Britt,

I have made a request to TI support center as you suggested. I hope it would work out.

Apart form this, I am also looking for the model of CSD22202W15 but it is not available on TI website.

Please advise where else I could find it?

Thanks.

Regards,

Bai N. Nguyen

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

MOSFET models for Cadence Spectre