TPS62410-Q1 WEBENCH Gain/Phase simulation

Toshio Ushikubo

Mastermind 9620 points

Other Parts Discussed in Thread: TPS62410-Q1

Hello,

I did the TPS62410-Q1 Gain/Phase simulation using WEBENCH and output is follows.

Loop Response graph doesn’t have Gain curve.

Please check and advise why Gain curve are not.

Best Regards.

over 8 years ago

0 Britt Brooks - Online Design Tools over 8 years ago

TI__Mastermind 41310 points

Ushikubo-san,

I have confirmed the issue you are seeing. We will have someone take a look at the issue and find a resolution.

0 Toshio Ushikubo over 8 years ago in reply to Britt Brooks - Online Design Tools

Mastermind 9620 points

Hello Britt-san,

Thank you for your reply.

Please let me know progress.

Best Regards.

0 Toshio Ushikubo over 8 years ago in reply to Toshio Ushikubo

Mastermind 9620 points

Hello Britt-san,

Please reply resolution.

Best Regards.

0 Britt Brooks - Online Design Tools over 8 years ago in reply to Toshio Ushikubo

TI__Mastermind 41310 points

Ushikubo-san,

We are planning to disable the OpVal chart for the Bode Plot. We have found some issues that will take time to debug, so we do not want display them until they are corrected. The simulation for Bode Plot has been updated and functions correctly for the device.

Once I know that the charts have been updated properly, I will post a follow-up here.

I apologize for the inconvenience. Thanks for your patience.

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TPS62410-Q1 WEBENCH Gain/Phase simulation