Tool/software: WEBENCH® Design Tools
Hello Webench team,
I would like to confirm the load transient result when output current slew rate is changed any speed.
However, I don't find any input area for changing slew rate.
Could you please tell me how to change the slew rate?
I simurated LMR23610-Q1.
Best Regards,
Yuki
Hi Yuki-san,
In WEBENCH, you can open the load transient simulation window and click on the load symbol. This should open up the component simulation parameters window. You can then modify the rise time and fall time to modify the slew rate. You can also modify I1,I2 which are the load currents during the load transient as well.
Regards,
Gerold
Hi Yuki-san,
These parameters are editable before running the simulations. However if you want to edit them after simulation, please click on "Show Latest Design Version" button (as shown in the below snapshot) and you will be able to edit the parameters and run the simulation.
Thanks.
