PMP20183: how to make the output HV is tunnable?&How to Inverting the Boost HV to -200V?

shuli yin

Prodigy 80 points

Part Number: PMP20183

1. How to make the output HV is tunnable with the control of MCU(PWM for wxample)? The HV range is 50-200V, is tunable.

2 How to Inverting the Boost HV to -200V? I need a negtive HV output.

Thanks.

over 6 years ago

0 Ryan Manack over 6 years ago

TI__Intellectual 2610 points

Hi Steven,

Please take a look at the attached design. It is tunable for -50V to -270V. The power topology is an inverting buck-boost with charge pumps used for quadrupling.

Thanks,
Ryan

PMP21223A(001)_Sch.PDF

0 shuli yin over 6 years ago in reply to Ryan Manack

Prodigy 80 points

Dear Ryan:

Really thanks for your reply, I want to know is there any application report, or intreoduction about this circuit?

Thanks very much!

Steven

0 Ryan Manack over 6 years ago in reply to shuli yin

TI__Intellectual 2610 points

Hi Steve,

Sure, check out the below documents.

www.ti.com/lit/an/slyt286/slyt286.pdf
https://www.eetimes.com/document.asp?doc_id=1273235

Thanks,
Ryan

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

PMP20183: how to make the output HV is tunnable?&How to Inverting the Boost HV to -200V?