TIDA-00122: L-inductance SPEC for the full-bridge structure

Tommy Tzeng

Part Number: TIDA-00122

Hi Sir,

sorry~is there L2(EE2005) an inductance specification in the TIDA-00122 reference design? because there is no in the BOM list. I would have datasheet for reference.

over 5 years ago

0 JohnFullilove over 5 years ago

TI__Expert 5120 points

Tommy, hello and thank you for your interest in Texas Instruments. We're inquiring with the original design team to determine if we can obtain the data for the L2 inductor. Unfortunately, as this is a very old design, it may take a day or so to run the information down.

Best Regards,

J. Fullilove
Texas Instruments
TI Designs

0 JohnFullilove over 5 years ago in reply to JohnFullilove

TI__Expert 5120 points

Tommy, it took a little longer than expected, but we found the L2 specs you were looking for. Please let us know if there is anything else you will need.

Best Regards,
J. Fullilove
Texas Instruments
TI Designs

0 JohnFullilove over 5 years ago in reply to JohnFullilove

TI__Expert 5120 points

Push Pull Tranformer-based PMP3715.doc Inductor Push Pull-PMP3715.doc

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TIDA-00122: L-inductance SPEC for the full-bridge structure