WEBENCH® Tools/LMR23630-Q1: Simulation at 2.1MHz

Jared Becker

Part Number: LMR23630-Q1

Tool/software: WEBENCH® Design Tools

Hi Team,

I am trying to simulate the LMR23630-Q1 at 2.1MHz, but for some reason the max frequency I can simulate at is 1.2MHz. Is there a reason the simulation will not allow 2.1MHz operation?

Thank you,

Jared

over 5 years ago

0 Gerold Dhanabalan - Online Design Tools over 5 years ago

TI__Genius 14455 points

Hi Jared,

The WEBENCH model has a frequency ceiling of 1.2MHz. We are fixing this. The part should allow you to operate at 2.1MHz depending on the variant that you chose.

Regards,

Gerold

0 Jared Becker over 5 years ago in reply to Gerold Dhanabalan - Online Design Tools

TI__Genius 11495 points

Hi Gerold,

Thank you for the response. When is the estimated fix date for the model?

Best,

Jared

0 Mahantesh Chanagoudar over 5 years ago in reply to Jared Becker

TI__Intellectual 1045 points

Hi Jared,

You can expect the fix on ti.com by 4th week of April.
Thank you,

Best Regards,
Mahantesh

0 Mahantesh Chanagoudar over 4 years ago in reply to Mahantesh Chanagoudar

TI__Intellectual 1045 points

Hi Jared,

The max frequency issue is resolved and fix is available on ti.com now. Please note that Cff is not there on schematic but present in BOM (so design is fine and it is just a schematic display issue) and we have fixed this issue and this fix will be available in next release.

Best Regards,
Mahantesh

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

WEBENCH® Tools/LMR23630-Q1: Simulation at 2.1MHz