Hi E2E,
Good day!
Do you have any information regarding the accuracy (x, y, and z) of the 3d scanning capability of TIDA-00254?
Thank you for your usual support.
Best regards,
Franz
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi E2E,
Good day!
Do you have any information regarding the accuracy (x, y, and z) of the 3d scanning capability of TIDA-00254?
Thank you for your usual support.
Best regards,
Franz
Hello Franz,
The accuracy will depend on many factors of your setup such as the baseline which is the distance from the camera and projector (greater baseline gives you higher accuracy), distance to object being scanned (greater distance results in worse accuracy), reflectivity of object, quality of calibration, etc. Therefore, it is hard to give an upper or lower bounds on accuracy.
Personally I have achieved accuracy as good as .34mm. However this could be better or worse depending on your setup.
Thanks,
Kyle
Hi Azad,
Thank you for providing this. However, there are no values indicated on the report.
Best regards,
Franz