PMP20199: Required Parameter Changes in Schematic.

Sravya Duvvuru

Part Number: PMP20199

Hii Expert

The Design of PMP20199 has Output current as 560mA.I need a the current at output as 600mA.

Could you please suggest me that either the component/parameter to be changed or whatever the changes required to obtain the current as 600mA.

Thankyou

With regards

D.Sravya

0 Robert Taylor1 over 4 years ago

Hi D.Sravya,

The design has some margin and will work at 0.6A.

If you refer to section 6 in the test results, the current regulation is around ~0.63-4A.

For additional margin, the only part that needs to change is the current sense resistor to a slightly lower value.

Thanks,

Robert

0 Sravya Duvvuru over 4 years ago in reply to Robert Taylor1

Thank you

Robert Taylor1

It was helpful.

With Regards

D.Sravya.

Simulation, hardware & system design tools forum