This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TIDA-01028: T3 symbol is wrong

Part Number: TIDA-01028
Other Parts Discussed in Thread: TEST

Hi,

I think the symobol of T3 is wrong on schematic diagram. (compare with T2 and T1 /they have the same pinouts/).We just built this board and the Flying probe machine was failing on the T3 test which were set based on schematic diagram.

T3 pin configuration is same as T2 and T1.

Could someone can confirm this error for me please?

Regards

Gabor

  • Hi Gabor,

    Hope you are doing good.. 

    Yes, I noted that error in the schematic symbol for T3 but in the layout symbols are same. Also noted input and output connections are ok. 

    I really sorry for the inconvenience caused to you and I will update schematic symbol. 

    Could you please try for manual soldering for these part. 

    Also, I would like to understand more about this project/ applications like an oscilloscope or high-speed digitizer etc so that I can help you further on this subject.

    Regards

    Anbu M