• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 40 subscribers
  • Views 225 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

PMP4497: Configuring for 1.8V

Juliana Rolandelli53
Prodigy 40 points
Part Number: PMP4497
Other Parts Discussed in Thread: TPS53632,

This design has the output voltage max at 1.2V, do you have any designs that go from 48V to 1.8V?

It looks like the TPS53632 limits the voltage to 1.2V

  • 0
    Prodigy 40 points

    Can you also comment on why PMP4497 is limited to 1.2 V vout, even though when TPS53632 is limited to 1.52 V

  • 0 in reply to Juliana Rolandelli53
    TI__Intellectual 2770 points

    Hello Juliana,

    at "standard" controllers min Vin is limited to Vref due to virtual short circuit at OpAmp input;
    this device got some more IP in it. Despite Vref 1.7V the 6-bit VID i/f allows Vout 500mV to 1.52V
    by resolution in 64 steps.

    BUT: another limitation needs to be considered by input voltage, switching frequency and number
    of phases - i.e. at  Fsw 1MHz max. output voltage is 1.28V !

    The spreadsheet helps to figure out the suited Fsw according to needed Vout.

    Best regards, Bernd