PSPICE-FOR-TI: ERROR(ORCAP-15052)

Takashi Onawa

Part Number: PSPICE-FOR-TI

Hi Team,

My customer got ERROR(ORCAP-15052) when trying to run their model simulation imported from OrCAD environment.
Could you tell me what should they do to be clear the error?

You can see the error pop up capture : here(Internal link)

Regards,

Takashi Onawa

over 4 years ago

0 Jackie Horn over 4 years ago

TI__Expert 5880 points

Hello Takashi,

Some features in OrCAD are not supported for PSpice for TI, which is a potential explanation. Could you please share the customer's project (see FAQ about archiving: e2e.ti.com/.../969692 )? If the customer does not want to share the project here in a public forum, feel free to contact me (Jacqueline Horn) internally through TI email.

Thank you,

Jackie

0 Takashi Onawa over 4 years ago in reply to Jackie Horn

TI__Genius 13200 points

Hi Jackie-san,

I got their project to solve this issue. Please down load : here(Internal link)
Could you check what is wrong?

Regards,

Takashi Onawa

0 Jackie Horn over 4 years ago in reply to Takashi Onawa

TI__Expert 5880 points

Hello Takashi,

I apologize for the delay. My connection was down during the snow storm in Dallas. I will have a look at the project today and let you know my findings in the next few days.

Thank you,

Jackie

+1 Jackie Horn over 4 years ago in reply to Jackie Horn

TI__Expert 5880 points

Hello Takashi-san,

I was able to reproduce this error. Please notice the warnings on lower pane for the following instances: DT652, D656, TR654, D653, D652, D651, TR651, Q1, and IC652. It appears to me that these devices are 3rd party models, which must be added manually. Please see the training video here and the FAQ here for using 3rd party models with PSpice for TI. Please also note that you must update the simulation profile if you change the location of your model files in the future.

Please let me know if you have further issues.

Thank you,

Jackie