PMP10936: T2 transformer datasheet required

Vikas Dabas1

Prodigy 145 points

Part Number: PMP10936

Hi,

Kindly provide datasheet for component T2 "RLTI-1143".

also suggest that if i can use simple RC clamping ckt instead of MOSFET clamping? If yes, please share RC values.

Also kindly let me know if i use simple diode in place of MOSFET(Losses apart, and just asking for capability)?

Vikas Dabas

over 4 years ago

0 Brian King over 4 years ago

TI__Intellectual 2885 points

Hi Vikas,

You can use an RCD clamp on the FET if you would like. I recommend starting with 20kohm and 0.01uF, but you will likely need to adjust the values in the circuit.

Also, yes you can replace the synchronous rectifier with a diode, but it will greatly increase the power loss.

regards,

Brian

0 Brian King over 4 years ago

TI__Intellectual 2885 points

Sorry, I am having problems uploading files again. I will keep trying to upload the transformer drawing.

0 Brian King over 4 years ago

TI__Intellectual 2885 points

Here is the drawing:

0 Brian King over 4 years ago in reply to Brian King

TI__Intellectual 2885 points

0 Brian King over 4 years ago in reply to Brian King

TI__Intellectual 2885 points

RLTI-1143 DATASHEET.pdf

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

PMP10936: T2 transformer datasheet required