Pspice for TI - Using markers with 3rd party components

Ethan Cruz

Hello -

Is there a way I can have more than three markers used during a transient analysis when using 3rd party components? I am trying to export the simulation data as a .csv and I need more than three markers. Is this possible? Why is there a limitation on the number of markers available for 3rd party parts?

Thanks,

Ethan

over 5 years ago

0 JC Zhu over 5 years ago

TI__Mastermind 37810 points

Hi Ethan,

What kind of 3rd party component do you use?

Thanks,
JC

0 Ethan Cruz over 5 years ago

Prodigy 30 points

Hi JC -

I am using two 3rd party models: one PIN diode and one LED model. However, I would like to simulate the circuit with multiple markers on the schematic. I was curious if there was a method to transferring the Pspice model specifications into a custom part that I can design within Pspice for TI to allow for more available markers in the simulation. I know Pspice for TI has no LED models unfortunately.

+1 JC Zhu over 5 years ago in reply to Ethan Cruz

TI__Mastermind 37810 points

Hi Ethan,

As you are exporting the results to csv, you can move the probes around and rerun the simulation a few times.

Thanks,
JC

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

Pspice for TI - Using markers with 3rd party components