Hi,
Been trying to disable and enable power saving multiple times throughout my program runtime, power saving at start works normally, I get very low power consumption.
when I disable power saving i see a jump in power consumption, about 2+ mA, not sure if this is normal but this is not the issue, the issue is after reenabling power saving again, the power consumption goes down but not as it was at start, it goes down to 1.5-2mA
any ideas why and how to solve this? i want to be able to stop power saving for a small period of time and then reenable it in that it would keep consumption to minimum.
Thank in advanced,
Jameel.