Hi,
Good Day.
In this board after the OAD process is complete, the system will wait for the newly downloaded image to be enabled. How does this enable the signal provided?
Please advise. Thank you very much.
Best Regards,
Ray Vincent
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi,
Good Day.
In this board after the OAD process is complete, the system will wait for the newly downloaded image to be enabled. How does this enable the signal provided?
Please advise. Thank you very much.
Best Regards,
Ray Vincent
Hey Ray,
There are a few stacks who implement an OAD solution, are you inquiring about this with regards to Bluetooth LE? Either way, the OAD enables the downloaded image using the Boot Image Manger (BIM), which should be programmed onto the board.
For more details, please see our OAD section in the User's Guide as well as our SimpleLink Academy modules here.
Hi Ammar,
Good Day. Please see below the response of our customer to your reply. Thank you very much.
I'm inquiring about the Bluetooth LE Project Zero app. I'm attempting to download the customer's firmware using the Simplelink starter mobile application; it successfully transferred the image and displays "download complete, waiting enable". What is the next step to perform after transferring the customer's FW?
Best Regards,
Ray Vincent
Hi Anmar,
Good Day. I would like to follow up on the customer's query. Thank you very much.
Best Regards,
Ray Vincent
Hey Ray,
Once the transfer is complete, the device should reset and boot into the newly transmitted image. If the device doesn't automatically reset, you can press the reset button on the dev kit being used to see if the OAD was successful.
Hi Anmar,
Good Day. Which is the reset button on the dev kit, button 1 or button 2? I can't find any user guide for the LP-CC2652R7. Please advise. Thank you very much.
Best Regards,
Ray Vincent
Hey Ray,
The reset button is the button at the top of the LP, near the USB connector, shown below: