Sensortag CC2650 Problem CS_DAP_0

SkyMan

Hi, when i debug my sensor, i have :

CS_DAP_0: Error connecting to the target: (Error -1170 @ 0x0) Unable to access the DAP. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK). (Emulation package 6.0.228.0)

I try to mass erase or flash with the image by default but it doesn't work.

My sensor is broken?? Or it's just a problem with image?

over 9 years ago

0 Sean2 over 9 years ago

TI__Mastermind 33460 points

Hi there,

Do you have any other programs open that might be connected to the device? (IAR, CCS, etc). It is not possible to have multiple programs connected to the XDS debugger at a time. I would close all of them, open flash programmer and try the mass erase again.

Can you confirm that you are using the XDS110 on the devPack debugger? Also can you confirm you version of Flash Programmer ?

0 SkyMan over 9 years ago in reply to Sean2

Expert 1275 points

Thanks, i resolve my problem when i update the flash programmer.

Bluetooth®︎

Bluetooth forum

Sensortag CC2650 Problem CS_DAP_0